Netgear GS752TXS Technical Information download pdf (Page 188)

188 | Chapter 6: Configuring Quality of Service

GS752TXS Smart Switch Software Administration Manual

• Mark IP DSCP. These packets are marked by DiffServ with the specified DSCP

value before being presented to the system forwarding element. This selection

requires that the DSCP value field be set.

5. Click Cancel to cancel the configuration on the screen and reset the data on the screen to

the latest value of the switch.

6. If you change any of the settings on the page, click Apply to send the updated configuration

to the switch. Configuration changes take effect immediately.

7. Click Refresh to refresh the page with the most current data from the switch.

Service Configuration

Use the Service Configuration page to activate a policy on an interface.

To display the page, click QoS

 DiffServ  Advanced  Service Configuration.

To configure DiffServ policy settings on an interface:

1. To configure DiffServ policy settings for a physical port, click PORTS.

2. To configure DiffServ policy settings for a Link Aggregation Group (LAG), click LAGS.

3. To configure DiffServ policy settings for both physical ports and LAGs, click ALL.

4. Select the check box next to the port or LAG to configure. You can select multiple ports and

LAGs to apply the same setting to the selected interfaces. Select the check box in the

heading row to apply the same settings to all interfaces.

5. To activate a policy for the selected interface(s) select the policy from the Policy In menu,

and then click Apply.

6. To remove a policy from the selected interface(s) select None from the Policy In menu, and

then click Apply.

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 317 318

No comments

Netgear GS752TXS Technical Information Page 188