Netgear WNDAP350 User Manual download pdf (Page 90)

ProSafe Dual Band Wireless-N Access Point WNDAP350 Reference Manual

4-2 Advanced Configuration

v1.1, November 2009

3. Configure the following TCP/IP configurations for using the WNDAP350 as a DHCP Server

for wireless clients.

• DHCP Server: By default, the Dynamic Host Configuration Protocol (DHCP) server on

the AP is disabled. If you enable it, all the wireless clients associated with the AP will get

their IP addresses, subnet mask and default gateway settings automatically from the AP.

• DHCP Server VLAN ID: All the stations that are part of the configured VLAN ID will

get their IP addresses only from the AP.

• Starting IP Address: Enter the starting IP address that can be assigned from the DHCP

server on this Access Point.

• Ending IP Address: Enter the Ending IP address that can be assigned from the DHCP

server on this Access Point

• Subnet Mask: The Access Point will assign the specified subnet mask to the connected

wireless stations.

• Gateway Address: The Access Point will assign this IP address as the default gateway for

any traffic beyond the local network.

• Primary DNS Server: The Access Point will assign this IP address as the primary

Domain Name Server used by the connected wireless stations.

Figure 4-1 DHCP server settings

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 135 136

No comments

Netgear WNDAP350 User Manual Page 90