Netgear WAG302v2 User Manual Page 70

  • Download
  • Add to my manuals
  • Print
  • Page
    / 104
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 69
NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
4-10 Advanced Configuration
v1.0, May 2006
Multi-Point Bridge Configuration
Multi-point bridge mode allows a wireless access point to bridge to multiple peer wireless access
points simultaneously. In addition, you can enable client associations with this WAG302v2. Multi-
Point Bridge mode configuration includes the following steps:
Enter the MAC addresses of the other access points in the fields provided.
Set the other bridge-mode access points to Point-to-Point Bridge mode, using the MAC
address of this WAG302v2 as the Remote MAC Address.
Use wireless security to protect this traffic.
The figure below shows an example of a Multi-Point Bridge mode configuration.
The following steps describe how to set up the Multi-Point Bridge configuration shown in
Figure 4-6.
1. Configure the Operating Mode of the WAG302v2 Wireless Access Points.
Because it is in a central location, configure WAG302v2 (AP 1) on LAN Segment 1 in
Point-to-Multi-Point Bridge mode and enter the MAC addresses of AP 2 and AP 3 in the
Remote MAC Address 1 and Remote MAC Address 2 fields.
Figure 4-6
AP 1
AP 2
Router
Internet
Hub or Switch
192.168.0.1
PCs
PCs
AP 3
“Master AP”
PCs
LAN Segment 1
LAN Segment 2
LAN Segment 3
Hub or Switch
Point-to-Multi-Point
Bridge mode
Point-to-Point
Bridge Mode
Point-to-Point
Bridge Mode
Page view 69
1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 103 104

Comments to this Manuals

No comments