Netgear WAG302v2 User Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 104
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
1-6 Introduction
v1.0, May 2006
Rear Panel
The numbers in Figure 1-2 correspond to the following features on the back of the WAG302v2:
1. 5 GHz detachable antenna. The 5 GHz antenna supports clients that use the 802.11a radio. The
WAG302v2 will not function properly if the 5 GHz antenna is not attached to the correct port.
The antenna frequency is labeled near its base.
2. 2.4 GHz detachable antenna. The 2.4 GHz antenna supports clients that use the 802.11b/g
radio. The WAG302v2 will not function properly if the 2.4 GHz antenna is not attached to the
correct port. The antenna frequency is labeled near its base.
3. Reset button. This restores the default factory settings.
4. Serial Console Port. Use the male DB-9 serial port for serial DTE connections.
5. RJ-45 Ethernet LAN/POE Port. Use the WAG302v2 Ethernet RJ-45 port to connect to an
Ethernet LAN through a device such as a hub, switch, router, or Power Over Ethernet (POE)
switch.
6. Power socket. This connects to the WAG302v2 power adapter.
802.11a WLAN Wireless LAN Link Activity Indicator (5 GHz)
Off No wireless link activity.
Green Blink Wireless link activity.
802.11g WLAN Wireless LAN Link Activity Indicator (2.4 MHz)
Off No wireless link activity.
Green Blink Wireless link activity.
Figure 1-2
LED Description
21
3456
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 103 104

Comments to this Manuals

No comments