NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual
Basic Installation and Configuration 2-7
v1.0, May 2006
Logging in to the WAG302v2 Using Its Default IP Address
After you install the WAG302v2, log in to it to configure the basic settings and the wireless
settings. The WAG302v2 is set, by default, with the IP address of 192.168.0.230 with DHCP
disabled. You can log in to the WAG302v2 by using the HTTP or HTTPS protocol.
1. Open a Web browser such as Internet Explorer, Netscape Navigator, or Mozilla Firefox.
2. Connect to the WAG302v2 by entering its default address of http://192.168.0.230 into your
browser.
3. A login window like the one shown below opens:
Note: Unless you change the IP address or enable the DHCP client on the WAG302v2,
the computer that you use to connect to the WAG302v2 should be configured with
an IP address that starts with 192.168.0.x and a Subnet Mask of 255.255.255.0.
Figure 2-3
Note: To use the HTTPS protocol, enter https://192.168.0.230 into your browser and
accept the certificate.
Figure 2-4
Comments to this Manuals