Netgear WAG302v2 User Manual download pdf (Page 87)

NETGEAR ProSafe Dual Band Wireless Access Point WAG302v2 Reference Manual

Command Line Reference C-3

v1.0, May 2006

Interface Naming Conventions

Table C-2 describes the interface naming conventions for the WAG302v2.

Ctrl-k Remove characters starting from cursor location to end of the current line.

(Clears the current line from the cursor forward.)

Ctrl-u Remove all characters before the cursor.

(Clears the current line from the cursor back to the CLI prompt.)

Ctrl-p

Up Arrow key

Display previous command in history.

(Ctrl-p and Ctrl-n let you cycle through a history of all executed commands like Up

and Down arrow keys typically do. Up/Down arrow keys also work for this.)

Ctrl-n

Down Arrow key

Display next command in history.

(Ctrl-p and Ctrl-n let you cycle through a history of all executed commands like Up

and Down arrow keys typically do. Up/Down arrow keys also work for this.)

Ctrl-d Exit the CLI. (At a blank command prompt, typing Ctrl-d closes the CLI.)

(Typing Ctrl-d within command text also removes characters, one at a time, at cursor

location like Ctrl-h.)

Warning: The CLI uses specific interface names the Web UI does not use. Many get

and set commands require that you enter interface names.

Note: Use the get interface command to display common information on all

interfaces, including IP addresses.

Table C-2 Interface Naming Convention

Interface Description

brvlan1 The Internal bridge represents the internal interface for the access point. To Telnet or SSH

into the access point, use the IP address for this interface. The

brvlan1 interface consists of:

• eth0 (or vlan <vlanid>

if you have VLANs configured)

• wlan0

• wlan1 (for the second radio)

brtrunk Internal bridge trunk interface.

Table C-1 Keyboard Shortcuts (continued)

Keyboard Shortcut Action on CLI

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 103 104

No comments

Netgear WAG302v2 User Manual Page 87