Netgear FVS114 User Manual download pdf (Page 142)

Reference Manual for the ProSafe VPN Firewall FVS114

9-2 Troubleshooting

202-10098-01, April 2005

LEDs Never Turn Off

When the firewall is turned on, the LEDs turn on briefly and then turn off. If all the LEDs stay on,

there is a fault within the firewall.

If all LEDs are still on one minute after power up:

• Cycle the power to see if the firewall recovers.

• Clear the firewall’s configuration to factory defaults. This will set the firewall’s IP address to

192.168.0.1. This procedure is explained in “Restoring the Default Configuration and

Password” on page 9-7.

If the error persists, you might have a hardware problem and should contact technical support.

LAN or Internet Port LEDs Not On

If either the LAN LEDs or Internet LED do not light when the Ethernet connection is made, check

the following:

• Make sure that the Ethernet cable connections are secure at the firewall and at the hub or

workstation.

• Make sure that power is turned on to the connected hub or workstation.

• Be sure you are using the correct cable:

When connecting the firewall’s Internet port to a cable or DSL modem, use the cable that was

supplied with the cable or DSL modem. This cable could be a standard straight-through

Ethernet cable or an Ethernet crossover cable.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 211 212

No comments

Netgear FVS114 User Manual Page 142