Netgear FVS114 User Manual download pdf (Page 99)

Reference Manual for the ProSafe VPN Firewall FVS114

Advanced Virtual Private Networking 6-11

202-10098-01, April 2005

The VPN Manual Policy fields are defined in the following table.

Table 6-1. VPN Manual Policy Configuration Fields

Field Description

General These settings identify this policy and determine its major characteristics.

Policy Name The name of the VPN policy. Each policy should have a unique policy

name. This name is not supplied to the remote VPN Endpoint. It is used to

help you identify VPN policies.

Remote VPN Endpoint The WAN Internet IP address of the remote VPN firewall or client to which

you wish to connect. The remote VPN endpoint must have this FVS114’s

WAN Internet IP address entered as its Remote VPN Endpoint.

Traffic Selector These settings determine if and when a VPN tunnel will be established. If

network traffic meets all criteria, then a VPN tunnel will be created.

Local IP The drop down menu allows you to configure the source IP address of the

outbound network traffic for which this VPN policy will provide security.

Usually, this address is from your network address space. The choices are:

• ANY for all valid IP addresses in the Internet address space

• Single IP Address

• Range of IP Addresses

• Subnet Address

Remote IP The drop down menu allows you to configure the destination IP address of

the outbound network traffic for which this VPN policy will provide security.

Usually, this address is from the remote site's corporate network address

space. The choices are:

• ANY for all valid IP addresses in the Internet address space

• Single IP Address

• Range of IP Addresses

• Subnet Address

Authenticating Header (AH)

Configuration

AH specifies the authentication protocol for the VPN header. These

settings must match the remote VPN endpoint.

Note: The Incoming settings here must match the Outgoing settings on the

remote VPN endpoint, and the Outgoing settings here must match the

Incoming settings on the remote VPN endpoint.

SPI - Incoming Enter a hexadecimal value (3 - 8 chars). Any value is acceptable, provided

the remote VPN endpoint has the same value in its Outgoing SPI field.

SPI - Outgoing Enter a hexadecimal value (3 - 8 chars). Any value is acceptable, provided

the remote VPN endpoint has the same value in its Incoming SPI field.

Enable Authentication Use this check box to enable or disable AH. Authentication is often not

used. In this case, leave the check box unchecked.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 211 212

Comments to this Manuals

No comments

Netgear FVS114 User Manual Page 99

Comments to this Manuals

Related products and manuals for Routers Netgear FVS114