Netgear FVS114 User Manual download pdf (Page 29)

Reference Manual for the ProSafe VPN Firewall FVS114

Connecting the Firewall to the Internet 3-5

202-10098-01, April 2005

With the VPN firewall router in its factory default state, your browser will automatically

display the NETGEAR Smart Wizard Configuration Assistant welcome page.

Figure 3-5: NETGEAR Smart Wizard Configuration Assistant welcome screen

Note: If you do not see this page, type http://www.routerlogin.net in the browser address bar

and press Enter. If you still cannot see this screen, see “How to Bypass the Configuration

Assistant” on page 3-9.

If you cannot connect to the VPN firewall router, verify your computer networking setup. It

should be set to obtain both IP and DNS server addresses automatically, which is usually so.

For help with this, see Appendix D, “Preparing Your Network or the animated tutorials on the

Resource CD.

2. Click OK. Follow the prompts to proceed with the Smart Wizard Configuration Assistant to

connect to the Internet.

3. Click Done to finish. If you have trouble connecting to the Internet, see “Troubleshooting

Tips” on page 3-6 to correct basic problems.

Note: The Smart Wizard Configuration Assistant only appears when the firewall is in its factory

default state. After you configure the VPN firewall router, it will not appear again. You can always

connect to the firewall to change its settings. To do so, open a browser such as Internet Explorer

and go to http://www.routerlogin.net. Then, when prompted, enter admin as the user name and

password for the password both in lower case letters.

You are now connected to the Internet!

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 211 212

No comments

Netgear FVS114 User Manual Page 29