Netgear FVG318 User Manual download pdf (Page 98)

ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual

5-20 Basic Virtual Private Networking

v1.0, September 2007

5. In the End Point Information section, enter the Remote WANs IP Address or Internet Name

and the Local WAN’s IP Address or Internet Name. Both local and remote ends must be

defined as either IP addresses or Internet Names (FQDNs).

6. In the Security Connection Remote Accessibility section, enter the remote LAN IP address

and Subnet Mask at the target endpoint that can use this tunnel.

You can view the VPNC recommended authentication and encryption settings used by the

VPN Wizard by clicking the VPN Wizard Default Values link.

Note: The Local IP Address field can be left as the default address unless you are

using a different IP Address or FQDN.

Figure 5-23

Note: The IP Address range on the remote LAN must be different from the IP

Address range on the local LAN.

Enter the new Connection

Name: (GtoG in this example)

Enter the pre-shared key:

(12345678 in this example)

Select the radio button:

A remote VPN Gateway

Enter the WAN IP address of

the remote VPN gateway:

(22.23.24.25 in this example)

Enter the LAN IP settings of the

remote VPN gateway. For

example:

• IP Address (192.168.3.1)

• Subnet Mask (255.255.255.0)

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 175 176

No comments

Netgear FVG318 User Manual Page 98