Netgear FVG318 User Manual Page 97

  • Download
  • Add to my manuals
  • Print
  • Page
    / 176
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 96
ProSafe 802.11g Wireless VPN Firewall FVG318 Reference Manual
Basic Virtual Private Networking 5-19
v1.0, September 2007
Setting Up a Gateway-to-Gateway VPN Configuration
The following procedure will show how to set the LAN IPs on each FVG318 to different subnets
and configure each properly for the Internet.
The LAN IP address ranges of each VPN endpoint must be different. The connection will fail
if both are using the NETGEAR default address range of 192.168.0.x.
In this example, LAN A uses 192.168.0.1 and LAN B uses 192.168.3.1.
To configure a gateway-to-gateway VPN tunnel using the VPN Wizard.
1. Log in to the FVG318 on LAN A at its default LAN address of http://192.168.0.1 with its
default user name of
admin and password of password.
2. Select VPN > VPN Wizard from the main menu. The VPN Wizard screen will display.
3. Select the Gateway radio box in the About VPN Wizard section.
4. In the Connection Name and Remote IP Type section, enter the Connection Name and the pre-
shared key.
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
Table 5-1 on page 5-4. If you have special requirements
not covered by these VPNC-recommended parameters, refer to Chapter 6,
“Advanced Virtual Private Networking” to set up the VPN tunnel.
Figure 5-22
FVG318 VPN Firewall
FVG318 VPN Firewall
Page view 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 175 176

Comments to this Manuals

No comments