Netgear 7300S User Manual download pdf (Page 289)

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Quality of Service (QoS) Commands 11-25

202-10088-01, March 2005

Restrictions Only one style of police command (simple, singlerate, tworate) is

allowed for a given class instance in a particular policy.

Policy Type In

Incompatibilities Mark IP DSCP, Mark IP Precedence

police-single-rate

This command is used to establish the traffic policing style for the specified class. The single-rate

form of the police command uses a single data rate and two burst sizes, resulting in three

outcomes: conform, exceed and violate. The conforming data rate is specified in kilobits-per-

second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is specified in

kilobytes (KB) as an integer from 1 to 128. The exceeding burst size is specified in kilobytes (KB)

as an integer from 1 to 128. Note that the exceeding burst size must be equal to or greater than the

conforming burst size.

For each outcome, the only possible actions are drop, set-cos-transmit, set-sec-cos-transmit, set-

dscp-transmit, set-prec-transmit, or transmit. In this singlerate form of the police command, the

conform action defaults to send, the exceed action defaults to drop, and the violate action defaults

to drop. These actions can be set with this command once the style has been configured.

For set-dscp-transmit, a <

dscpval> value is required and is specified as either an integer from 0 to

63, or symbolically through one of the following keywords:

af11, af12, af13, af21, af22, af23, af31, af32,

af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef

For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.

Format

police-single-rate {<1-4294967295> <1-128> <1-128>

conform-action {drop | set-cos-transmit <0-7> | set-

sec-cos-transmit <0-7> | set-prec-transmit <0-7> |

set-dscp-transmit <0-63> | transmit} exceed-action

{drop | set-cos-transmit <0-7> | set-sec-cos-transmit

<0-7> | set-prec-transmit <0-7> | set-dscp-transmit

<0-63> | transmit} [violate-action {drop | set-cos-

transmit <0-7> | set-sec-cos-transmit <0-7> | set-

prec-transmit <0-7> | set-dscp-transmit <0-63> |

transmit}]}

Mode Policy-classmap Config

Restrictions Only one style of police command (simple, singlerate, tworate) is

allowed for a given class instance in a particular policy.

Policy Type In

Incompatibilities Mark IP DSCP, Mark IP Precedence

1 2 ... 284 285 286 287 288 289 290 291 292 293 294 ... 401 402

No comments

Netgear 7300S User Manual Page 289