Netgear 7300S User Manual download pdf (Page 285)

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Quality of Service (QoS) Commands 11-21

202-10088-01, March 2005

Incompatibilities Expedite (all forms)

bandwidth percent

This command identifies a minimum amount of bandwidth to be reserved for the specified class

instance within the named policy using a relative rate notation. The committed information rate is

specified as a percentage of total link capacity and is an integer from 1 to 100.

Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in

a particular direction.

Note: The bandwidth kbps and percent commands are alternative ways to specify the same

bandwidth policy attribute.

Format

bandwidth percent <1-100>

Mode Policy-classmap Config

Restrictions The sum of the committed information rate values for all band-

width and expedite commands defined within a policy must not

exceed the available link bandwidth of the interface to which that

policy is assigned. Violation of this requirement shall prevent

successful attachment of a policy to the interface, or shall cause

this command to fail if the policy is already in service on one or

more interfaces.

Policy Type Out

Incompatibilities Expedite (all forms)

class

This command creates an instance of a class definition within the specified policy for the purpose

of defining treatment of the traffic class through subsequent policy attribute statements. The

classname> is the name of an existing DiffServ class. Note that this command causes the

specified policy to create a reference to the class definition.

Note: The CLI mode is changed to Policy-classmap Config when this command is successfully

executed.

Format

class <classname>

Mode Policy-Map Config

1 2 ... 280 281 282 283 284 285 286 287 288 289 290 ... 401 402

No comments

Netgear 7300S User Manual Page 285