Netgear 7300S User Manual download pdf (Page 83)

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

Switching Commands 8-13

202-10088-01, March 2005

show logging

This command displays the trap log maintained by the switch. The trap log contains a maximum of

256 entries that wrap.

Format

show logging

Mode Privileged EXEC

Number of Traps since last reset The number of traps that have occurred since the last

reset of this device.

Number of Traps since log last displayed The number of traps that have occurred

since the traps were last displayed. Getting the traps by any

method (terminal interface display, Web display, upload file from

switch etc.) will result in this counter being cleared to 0.

Log The sequence number of this trap.

System Up Time The relative time since the last reboot of the switch at which this

trap occurred.

Trap The relevant information of this trap.

Note: Trap log information is not retained across a switch reset.

show mac-addr-table

This command displays the forwarding database entries. If the command is entered with no

parameter, the entire table is displayed. This is the same as entering the optional

all parameter.

Alternatively, the administrator can enter a MAC Address to display the table entry for the

requested MAC address and all entries following the requested MAC address.

Format

show mac-addr-table [<macaddr> | all]

Mode Privileged EXEC

Mac Address

A unicast MAC address for which the switch has forwarding and or filtering

information. The format is 6 or 8 two-digit hexadecimal numbers that are separated by colons,

for example 01:23:45:67:89:AB. In an IVL system the MAC address will be displayed as 8

bytes.

Slot/Port The port which this address was learned.

if Index This object indicates the ifIndex of the interface table entry asso-

ciated with this port.

Status The status of this entry. The meanings of the values are:

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 401 402

No comments

Netgear 7300S User Manual Page 83