Netgear DGND3300 User Manual download pdf (Page 25)

Chapter 2. Wireless Settings | 25

N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual

and default password of password, or using whatever LAN address and password you

have set up.

2. On the N300 wireless modem router main menu, select Add WPS Client, and then click

Next. The following screen displays:

Figure 12.

By default, the Push Button (recommended) radio button is selected.

3. Either press the N300 wireless modem router dome for a few seconds, which works as a

WPS button, or click the onscreen button.

The N300 wireless modem router tries to communicate with the client for 2 minutes.

4. Go to the client wireless computer, and run a WPS configuration utility. Follow the utility’s

instructions to click a WPS button.

5. Go back to the N300 wireless modem router screen to check for a message.

The N300 wireless modem router WPS screen displays a message confirming that the

client was added to the wireless network. The N300 wireless modem router generates an

SSID and implements WPA/WPA2 wireless security. The N300 wireless modem router

will keep these wireless settings unless you change them or you clear the Keep Existing

Wireless Settings check box in the Advanced Wireless Settings screen. See Restricting

Access to Your N300 Wireless Modem Router on page 29.

6. Note the new SSID and WPA/WPA2 password for the wireless network. You can view these

settings in the Wireless Settings screen. See Manually Configuring Your Wireless Settings

on page 18.

To access the Internet from any computer connected to your N300 wireless modem router,

launch a browser such as Microsoft Internet Explorer or Mozilla Firefox. You should see the

N300 wireless modem router’s Internet LED blink, indicating communication to the ISP.

Note: If no WPS-capable client devices are located during the 2-minute

time frame, the SSID will not be changed, and no security will be

implemented on the N300 wireless modem router.

Using PIN Entry to Add a WPS Client

Any wireless computer or wireless adapter that will connect to the N300 wireless modem

router wirelessly is a client. The client must support a WPS PIN, and must have a WPS

configuration utility, such as the NETGEAR Smart Wizard or Atheros Jumpstart.

WPS button

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 176 177

No comments

Netgear DGND3300 User Manual Page 25