Netgear DGND3300 User Manual Page 80

  • Download
  • Add to my manuals
  • Print
  • Page
    / 177
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 79
80 | Chapter 6. Virtual Private Networking
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual
configuration mismatches between your N300 Wireless Dual Band ADSL2+ Modem
Router DGND3300v2 and the corresponding VPN endpoint gateway or client workstation.
Setting Up a Client-to-Gateway VPN Configuration
Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN client and a
network gateway involves two steps, described in the following sections:
Step 1: Configure the Client-to-Gateway VPN Tunnel on page 80 describes how to use
the VPN Wizard to configure the VPN tunnel between the remote PC and network
gateway.
Step 2: Configure the NETGEAR ProSafe VPN Client on page 83 shows how to configure
the NETGEAR ProSafe VPN client endpoint.
Figure 51. N300 Wireless Modem Router DGND3300v2 Client-to-Gateway VPN Tunnel
Step 1: Configure the Client-to-Gateway VPN Tunnel
This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in Table 2 on page 79. If you have special requirements not covered
by these VPNC-recommended parameters, see Setting Up VPN Tunnels in Special
Circumstances on page 100 for information about how to set up the VPN tunnel.
The following worksheet identifies the parameters used in this procedure. For a blank
worksheet, see Planning a VPN on page 78.
Table 3. VPN Tunnel Configuration Worksheet
Parameter Value to Be Entered Field Selection
Connection Name RoadWarrior N/A
Pre-Shared Key 12345678 N/A
Secure Association N/A Main Mode Manual Keys
Perfect Forward secrecy N/A Enabled Disabled
Encryption Protocol N/A DES 3DES
VPN tunnel
Internet
PC running NETGEAR
ProSafe VPN client
22.23.24.25
0.0.0.0
IP: 192.168.3.1
Page view 79
1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 176 177

Comments to this Manuals

No comments