Netgear FVS336G-300NAS Specifications download pdf (Page 463)

100

101

Set Up Virtual Private Networking with SSL Connections

463

ProSAFE Dual WAN Gigabit WAN SSL VPN Firewall FVS336Gv3

192.168.1.100 are assigned to devices on the local network, start the client address

range at 192.168.1.101, or choose an entirely different subnet altogether.

• The VPN tunnel client cannot contact a server on the local network if the VPN tunnel

client’s Ethernet interface shares the same IP address as the server or the VPN firewall.

(For example, if your computer has a network interface IP address of 10.0.0.45, you

cannot contact a server on the remote network that also has the IP address 10.0.0.45.)

• Select whether you want to enable full-tunnel or split-tunnel support based on your

bandwidth:

- A full tunnel sends all of the client’s traffic across the VPN tunnel.

- A split tunnel sends only traffic that is destined for the local network based on the

specified client routes. All other traffic is sent to the Internet. A split tunnel allows you

to manage bandwidth by reserving the VPN tunnel for local traffic only.

• If you enable split-tunnel support and you assign an entirely different subnet to the VPN

tunnel clients from the subnet that is used by the local network, you must add a client

route to ensure that a VPN tunnel client connects to the local network over the VPN

tunnel.

Configure the Client IPv4 Address Range

The following procedure describes how to define the client IPv4 address range.

 To define the client IPv4 address range:

1. On your computer, launch an Internet browser.

2. In the address field of your browser, enter the IP address that was assigned to the VPN

firewall during the installation process.

The VPN firewall factory default IP address is 192.168.1.1.

The NETGEAR Configuration Manager Login screen displays.

3. In the Username field, type your user name and in the Password / Passcode field, type

your password.

For the default administrative account, the default user name is admin and the default

password is password.

4. If you changed the default domain or were assigned a domain, from the Domain menu,

select the domain.

If you did not change the domain or were not assigned a domain, leave the menu

selection at geardomain.

5. Click the Login button.

The Router Status screen displays.

6. Select VPN > SSL VPN > SSL VPN Client.

The SSL VPN Client screen displays the IPv4 settings. The following figure shows an

example.

1 2 ... 458 459 460 461 462 463 464 465 466 467 468 ... 692 693

Comments to this Manuals

No comments

Netgear FVS336G-300NAS Specifications Page 463

Comments to this Manuals