Netgear WNAP320 User's Guide download pdf (Page 56)

56 | Chapter 4. Management

ProSafe Wireless-N Access Point WNAP320 Reference Manual

SNMP Management

To set up an SNMP management interface:

1. Select Ma

intenance > Remote Management > SNMP. The SNMP screen displays:

Figure 29.

2. Specify the settings as explained in the following table:

3. Click Apply to save

your settings.

Table 15. SNMP Settings

Field Description

SNMP Select the Enable radio button to allow the SNMP network management

software, such as HP OpenView, to manage the wireless access point

through SNMPv1/v2 protocol. By default, the Disable radio button is

selected.

Read-Only Community Name Enter the community string to allow the SNMP manager to read the

ireless access point’s Management Information Base (MIB) objects. The

default is public.

Read-Write Community Name Enter the community string to allow the SNMP manager to read and write

the wir

eless access point’s MIB objects. The default is private.

Trap Community Name The community string to allow the SNMP manager to send traps. The

default is

trap.

IP Address to Receive Traps The IP address of the SNMP manager

to receive traps sent from the

wireless access point.

Trap Port The port number of the SNMP manager to receive traps sent from the

ireless access point. The default is 162.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 125 126

No comments

Netgear WNAP320 User's Guide Page 56