Netgear WNAP320 User's Guide Page 59

  • Download
  • Add to my manuals
  • Print
  • Page
    / 126
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 58
Chapter 4. Management | 59
ProSafe Wireless-N Access Point WNAP320 Reference Manual
Web Browser Upgrade Procedure
To use a Web browser to upgrade the wireless access point firmware:
1. Download th
e new software file from the NETGEAR website and save it to your hard
disk.
2. If necessary
, unzip the new software file.
3. If available,
read the release notes before upgrading the software.
4. Select Main
tenance > Upgrade > Firmware Upgrade. The Firmware Upgrade screen
displays:
Figure 32.
5. Click Browse and locate the image (.zip) upgrade file.
6. Click App
ly to initiate the upgrade process.
During the upgrade process, the wireless access point auto
matically restarts. The
upgrade process typically takes several minutes. When the Test LED turns off, wait a few
more seconds before doing anything with the wireless access point.
7. V
erify that the new software file has been installed by selecting Monitoring > System. The
System screen displays (see Figure 40 on p
age 66). The firmware version is shown in the
Access Point Information section of the screen.
TFTP Server Upgrade Procedure
To use this method, you must have a TFTP server set up.
To use a TFTP server to upgrade the wireless access point firmware:
1. Download th
e new software file from the NETGEAR website and save it to your hard
disk.
2. Place the sof
tware file in your TFTP server location. (You do not need to unzip the file.)
3. If available,
read the release notes before upgrading the software.
Page view 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 125 126

Comments to this Manuals

No comments