Netgear WNAP320 User's Guide Page 76

  • Download
  • Add to my manuals
  • Print
  • Page
    / 126
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 75
Chapter 5. Advanced Configuration | 76
5
5. Advanced Configuration
This chapter describes how to configure the advanced features of your ProSafe Wireless-N
Access Point WNAP320. The chapter includes the following sections:
Spanning Tree Protocol and 802.1Q VLAN on this page
Hotspot Settings on p
age 78
Configure Advanced Wireless Settings o
n page 79
Configure Advanced QoS Settings on
page 81
Configure Wireless Bridging on p
age 84
Spanning Tree Protocol and 802.1Q VLAN
The advanced General system settings screen allows you to enable the Spanning Tree
Protocol (STP) and configure the VLANs.
STP provides network traffic optimization in locations wh
ere multiple wireless access points
are active.
The 802.1Q VLAN protocol on the wireless access point logically separates traffic on the
sam
e physical network:
Unt
agged VLAN. When the wireless access point sends frames that are associated with
the untagged VLAN from its Ethernet interface, those frames are untagged. When the
wireless access point receives untagged frames over its Ethernet interface, those frames
are assigned to the untagged VLAN.
Note: Select the Untagged VLAN check box only if the hubs and switches
on your LAN support the 802.1Q VLAN protocol. Likewise, change
the untagged VLAN value only if the hubs and switches on your LAN
support the 802.1Q VLAN protocol. Selecting the Untagged VLAN
check box or changing the untagged VLAN value will result in a loss
of IP connectivity if the hubs and switches on your LAN have not yet
been configured with the corresponding VLAN.
Page view 75
1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 125 126

Comments to this Manuals

No comments