Netgear WNDR4000 User Manual download pdf (Page 28)

28 | Chapter 3. Wireless Settings

N750 Wireless Dual Band Gigabit Router WNDR4000 User Manual

Wi-Fi Protected Setup (WPS) Method

Wi-Fi Protected Setup (WPS) is a standard that lets you easily join a secure wireless network

with WPA or WPA2 wireless security. The wireless router automatically sets security for each

computer or device that uses WPS to join the wireless network. To use WPS, make sure that

your wireless devices are Wi-Fi certified and support WPS. NETGEAR products that use

WPS call it Push 'N' Connect.

Note: If the wireless network name (SSID) changes each time you add a

WPS client, the Keep Existing Wireless Settings check box on the

Advanced Wireless Settings screen has been cleared. See

Advanced Wireless Settings on page 75 for more information about

this setting.

You can use a WPS button or the wireless router interface method to add wireless computers

and devices to your wireless network.

WPS Button Method

1. Press the WPS button on the wireless router front panel.

2. Wit

hin 2 minutes, press the WPS button on your wireless computer or device, or follow the

WPS instructions that came with the computer.

The device is now connected to your wireless router.

3. Repeat

steps 1–2 to add other WPS wireless computers or devices.

Router Interface Method

1. Select Add WPS Client at the top of the wireless router menus.

2. Click Next.

The following screen lets you select the method for adding the WPS client.

WPS Push Button method

3. Select either Push Button or PIN Number.

1. For a list of other Wi-Fi-certified products available from NETGEAR, go to http://www.wi-fi.org.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 103 104

No comments

Netgear WNDR4000 User Manual Page 28