Netgear WC7600 User Manual download pdf (Page 130)

Discover and Manage Access Points

130

ProSAFE Wireless Controller WC7600

You must add the access point to the managed list, change its IP address, and run

discovery again to discover the next access point with that IP address.

• For more information, see Resolve Problems with Access Points on page 300.

12. T

o run the discovery process again, click the Restart button.

13. T

o designate an access point as a remote access point, from the Site menu, select

Remote.

By default, all discovered access points are designated as Local. The Remote and Local

designations are for organization only

Note: The wireless controller cannot discover remote access points over a

site-to-site VPN connection or behind a remote NAT router without a

VPN connection. This capability will be added in a future release.

14. Either select individual access points to be added to the managed list or select all access

points to be added to the managed list:

• Select individual check boxes for discovered access points that you want to add to the

managed list.

• Select the check box in the upper right of the table heading to add all discovered

access points to the managed list.

15. Click the Add button.

Depending on the type of access points that have been discovered, a screen that lets you

enter or ignore a login name and password might display

16. If necessary, enter the login name and password.

The Managed AP List screen displays. Because this screen is wide, it is shown in the

following two figures:

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 306 307

No comments

Netgear WC7600 User Manual Page 130