Netgear WC7600 User Manual download pdf (Page 45)

RF Planning

ProSAFE Wireless Controller WC7600

 To delete a building:

1. Select the check box that corresponds to the building that you want to delete, or select

the check box at the top row of the table to delete all buildings.

2. Click Delete.

Specify Access Point Requirements

After you have defined the buildings and floors, you need to specify the following RF

requirements for each floor and each supported access point model (WNAP210v2,

WNAP320, WNDAP350, and WNDAP360):

• Frequency band. The radio frequency to be used (802.11b//jointfilesconvert/28571/bg/ng or 802.11a/na).

• Signal quality. The signal strength that you expect for the WLAN. This setting

determines the automatic channel allocation and automatic transmission power of the

access points (see the explanation in the table later in this section).

• Number of client per access point. The total number of clients that you expect to be

supported on each access point.

• Total number of clients per floor. The total number of clients that you expect to be

supported on each floor.

Along with the floor dimensions, these settings determine the estimated number of access

points. A screen lets you visually optimize the access point locations for best coverage.

 To specify the WLAN requirements for a floor, estimate the number of access points

required, and view their suggested locations:

1. Select Plans > Planning. The Planning Buildings screen displays with the Local

Building tab and associated screen in view. To specify the information for a remote

building, click the Remote Building tab.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 306 307

No comments

Netgear WC7600 User Manual Page 45