Netgear ProSafe FS728TP User Manual Page 125

  • Download
  • Add to my manuals
  • Print
  • Page
    / 248
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 124
FS728TP Smart Switch Software Administration Manual
4-30 Configuring Switching Settings
v1.1, September 2009
BPDU Handling – Select the method of handling STP BPDUs (Bridge Protocol Data
Units) when STP is disabled on the device or interface. The possible field values are:
Filtering – Indicates BPDUs are filtered.
Flooding – Indicates BPDUs are flooded to all ports in the system. This is the default.
Bridging – Indicates BPDUs are bridged to all ports in the VLAN.
Status
Bridge Identifier – Displays the Bridge priority and MAC address.
Time Since Topology Change – Displays the amount of time that has elapsed since the
bridge was initialized or reset, and the last topographic change that occurred. The time is
displayed in a day-hour-minute format, such as 2 days 5 hours and 10 minutes.
Designated Root – Displays the Root Bridge priority and MAC address.
Root Port – Indicates the port number that offers the lowest cost path from this bridge to
the Root Bridge. This field is significant when the bridge is not the Root Bridge. The
default is zero.
Max Age (Sec) – Displays the device Maximum Age Time. The Maximum Age Time is
the amount of time in seconds a bridge waits before sending configuration messages. The
default Maximum Age Time is 20 seconds.
Forward Delay (Sec) – Displays the device Forward Delay Time. The Forward Delay
Time is the amount of time in seconds a bridge remains in a listening and learning state
before forwarding packets. The default is 15 seconds.
Hello Time (Sec) – Displays the device Hello Time. The Hello Time indicates the amount
of time in seconds a Root Bridge waits between configuration messages. The default is 2
seconds.
CST Regional Root – Displays the Common STP regional bridge priority and MAC
address.
2. Select Enable or Disable in the Spanning Tree State provided field.
3. Select STP, RSTP or MSTP in the STP Operation Mode provided field.
4. If MSTP operation mode were selected, Enter a Configuration Name, a Configuration
Revision Level in the provided fields.
5. Select an Bridge Protocol Data Unit (BPDU) packet option from the BPDU Handling field.
This field is available only when STP is disabled.
6. Click APPLY to update the device.
Page view 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 247 248

Comments to this Manuals

No comments