Netgear ProSafe FS728TP User Manual Page 121

  • Download
  • Add to my manuals
  • Print
  • Page
    / 248
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 120
FS728TP Smart Switch Software Administration Manual
4-26 Configuring Switching Settings
v1.1, September 2009
The Basic STP Configuration screen contains the following fields:
Global Settings
Spanning Tree State – Select the STP state on the device. The possible field values are:
Disable – Disables STP on the device.
Enable – Enables STP on the device. This is the default value.
STP Operation Mode – Specifies the STP mode enabled on the device. The possible field
values are:
STP – Enables Classic STP on the device.
RSTP – Enables Rapid STP on the device. This is the default value.
MSTP – Enables Multiple STP on the device.
Configuration Name – Enter the user-defined configuration name. The maximum length
is 32 characters. The Configuration Name is required as part of the MSTP configuration.
Configuration Revision Level – Defines an unsigned 16-bit number that identifies the
revision of the current STP configuration. The Configuration Revision Number is required
as part of the MSTP configuration. The possible field range is 0-65535.
Figure 4-17
Page view 120
1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 247 248

Comments to this Manuals

No comments