FS728TP Smart Switch Software Administration Manual
4-6 Configuring Switching Settings
v1.1, September 2009
– Up – Indicates the LAG is currently linked and forwarding traffic.
– Down – Indicates the LAG is currently not linked.
• Reactivate Suspended – Select the action to apply to a suspended LAG. The possible
field values are:
– Enable – Reactivates the suspended LAG.
– Disable – Does not reactivate the suspended LAG.
• Type – Displays the LAG type. The possible field values are:
– Static – Indicates the LAG is configured manually.
– LACP – Indicates the LAG is configured automatically.
• Speed – Select the data transmission rate for the LAG. The LAG type determines what
speed setting options are available. The possible field values are:
– 10M – Indicates the LAG is currently operating at 10 Mbps.
– 100M – Indicates the LAG is currently operating at 100 Mbps.
– 1000M – Indicates the LAG is currently operating at 1000 Mbps.
• Duplex Mode – Displays the duplex mode of the LAG. The possible field values are:
– Full – Indicates the interface supports transmission between the device and its link
partner in both directions simultaneously.
– None – Indicates Duplex mode is not enabled on the LAG.
• Auto Negotiation – Select the auto negotiation status of the LAG. Auto Negotiation is a
protocol between two link partners that enables a port to advertise its transmission rate and
flow control abilities to its partner. Auto Negotiation is enabled by default. The possible
field values are:
– Enable – Enables auto negotiation.
– Disable – Disables auto negotiation.
• Flow Control – Select the flow control status of the LAG. Operates when the LAG is in
full duplex mode. Flow Control is disabled by default. The possible field values are:
– Enable – Enables flow control.
– Disable – Disables flow control.
2. Select the interface.
3. Enter or modify the fields in the first row.
Comments to this Manuals