Netgear GS748TS User Manual Page 96
- Page / 232
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
GS700TS Smart Switch Software Administration Manual
4-3 Configuring Switching Settings
v1.0, June 2009
– 10M – Indicates the port is currently operating at 10 Mbps.
– 100M – Indicates the port is currently operating at 100 Mbps.
– 1000M – Indicates the port is currently operating at 1000 Mbps.
• Duplex Mode – Select the port duplex mode. This field is configurable only when auto
negotiation is disabled and the port speed is set to 10M or 100M. The possible field values
are:
– Half – Indicates the interface supports transmission between the device and the client
in only one direction at a time.
– Full – Indicates the interface supports transmission between the device and its link
partner in both directions simultaneously.
– Auto – Indicates the interface supports transmission between the device and the link
partner based on the transmission mode of the link partner.
• Auto Negotiation – Select the port auto negotiation status. Auto negotiation is a protocol
between two link partners that enables a port to advertise its transmission rate, duplex
mode, and flow control abilities to its partner. The possible field values are:
– Enable – Enables auto negotiation. This is the default value.
– Disable – Disables auto negotiation.
• Back Pressure – Select the back pressure mode of the Port. Back Pressure mode is used
with half duplex mode to disable ports from receiving messages. Back Pressure mode is
disabled by default. The possible field values are:
– Enable – Enables back pressure mode.
– Disable – Disables back pressure mode.
• Flow Control – Select the flow control status of the port. Operates when the port is in full
duplex mode. Flow control is disabled by default. The possible field values are:
– Enable – Enables flow control.
– Disable – Disables Flow control.
• MDI/MDIX – Select the MDI/MDIX status of the port. Hubs and switches are
deliberately wired opposite the way end stations are wired, so that when a hub or switch is
connected to an end station, a straight through Ethernet cable can be used and the pairs
will match up properly. When two hubs or switches are connected to each other or two end
stations are connected to each other, a crossover cable is used to ensure that the correct
pairs are connected. The possible field values are:
- GS700TS Smart Switch 1
- Software Administration 1
- EU Statement of Compliance 3
- Customer Support 3
- Internet/World Wide Web 3
- Contents 5
- About This Manual 10
- About This Manual xi 11
- How to Use This Manual 12
- How to Print this Manual 13
- Revision History 13
- Chapter 1 14
- Switch Management Interface 15
- Network with a DHCP Server 16
- Figure 1-1 17
- Figure 1-2 17
- Network without a DHCP Server 18
- Stackable Smart Switch 19
- Web Access 20
- Additional Utilities 21
- Password Change 22
- Firmware Upgrade 22
- Figure 1-6 23
- Chapter 2 24
- The Navigation Menu 25
- Device Management Buttons 26
- Informational Services 27
- Figure 2-3 28
- Figure 2-4 28
- Figure 2-5 29
- Figure 2-6 29
- Figure 2-10 31
- Figure 2-11 32
- Figure 2-12 32
- Figure 2-13 33
- Figure 2-14 33
- Figure 2-15 34
- Figure 2-16 34
- Figure 2-17 35
- Chapter 3 36
- Managing System Settings 36
- Managing System Settings 3-2 37
- Figure 3-1 37
- V1.0, June 2009 38
- IP Configuration 39
- 3-5 Managing System Settings 40
- Managing System Settings 3-6 41
- Figure 3-3 41
- . The Secondary SNTP 42
- Device View 43
- Stacking 43
- Operation Modes 44
- Understanding Stack Topology 44
- Stacking Ports 45
- Stacking Members and Unit No 45
- 3-11 Managing System Settings 46
- Inserting a Stacking Member 47
- Exchanging Stacking Members 47
- Switching the Stacking Master 48
- Managing System Settings 3-14 49
- When the 49
- Figure 3-6 49
- 3-15 Managing System Settings 50
- Figure 3-7 50
- Managing System Settings 3-16 51
- Figure 3-8 51
- 3-17 Managing System Settings 52
- SNMPv1/v2 53
- 3-19 Managing System Settings 54
- Figure 3-9 54
- Managing System Settings 3-20 55
- 3-21 Managing System Settings 56
- Figure 3-10 56
- Managing System Settings 3-22 57
- 3-23 Managing System Settings 58
- Figure 3-11 58
- Managing System Settings 3-24 59
- Figure 3-12 59
- 3-25 Managing System Settings 60
- Figure 3-13 60
- Managing System Settings 3-26 61
- 3-27 Managing System Settings 62
- Figure 3-14 62
- Managing System Settings 3-28 63
- Figure 3-15 63
- 3-29 Managing System Settings 64
- Managing System Settings 3-30 65
- Figure 3-16 65
- 3-31 Managing System Settings 66
- Managing System Settings 3-32 67
- Figure 3-17 67
- 3-33 Managing System Settings 68
- Figure 3-18 68
- Managing System Settings 3-34 69
- 3-35 Managing System Settings 70
- Managing System Settings 3-36 71
- Figure 3-19 71
- 3-37 Managing System Settings 72
- Figure 3-20 72
- Managing System Settings 3-38 73
- 3-39 Managing System Settings 74
- Figure 3-21 74
- 3-41 Managing System Settings 76
- Figure 3-22 76
- Managing System Settings 3-42 77
- 3-43 Managing System Settings 78
- Figure 3-23 78
- Managing System Settings 3-44 79
- 3-45 Managing System Settings 80
- Figure 3-24 80
- Managing System Settings 3-46 81
- 3-47 Managing System Settings 82
- Figure 3-25 82
- Managing System Settings 3-48 83
- Figure 3-26 83
- 3-49 Managing System Settings 84
- Managing System Settings 3-50 85
- 3-51 Managing System Settings 86
- Figure 3-27 86
- Managing System Settings 3-52 87
- Figure 3-28 87
- 3-53 Managing System Settings 88
- Managing System Settings 3-54 89
- 3-55 Managing System Settings 90
- LLDP Statistics 91
- 3-57 Managing System Settings 92
- Figure 3-29 92
- Managing System Settings 3-58 93
- Chapter 4 94
- Figure 4-1 95
- Figure 4-2 98
- Figure 4-3 100
- Advanced 101
- Figure 4-5 102
- Figure 4-6 104
- Figure 4-7 105
- Figure 4-8 105
- Figure 4-9 106
- Figure 4-10 108
- Figure 4-12 111
- Figure 4-13 112
- Figure 4-14 113
- Voice VLAN 114
- Figure 4-16 115
- Properties 117
- Port Setting 118
- Figure 4-19 120
- Figure 4-20 122
- Figure 4-22 127
- Figure 4-23 128
- Figure 4-24 130
- Figure 4-25 133
- Figure 4-26 134
- Multicast 136
- The Multicast 141
- Figure 4-30 141
- The Multicast Forward 142
- Figure 4-31 143
- Address Table 144
- Figure 4-32 145
- Figure 4-34 147
- Figure 4-35 148
- Chapter 5 150
- Configuring QoS 150
- Configuring QoS 5-2 151
- 5-3 Configuring QoS 152
- Figure 5-1 152
- Configuring QoS 5-4 153
- Figure 5-2 153
- 5-5 Configuring QoS 154
- Figure 5-3 154
- Configuring QoS 5-6 155
- Figure 5-4 155
- Configuring QoS 5-8 157
- Figure 5-5 157
- 5-9 Configuring QoS 158
- Figure 5-6 158
- Configuring QoS 5-10 159
- Figure 5-7 159
- 5-11 Configuring QoS 160
- Configuring QoS 5-12 161
- Figure 5-8 161
- 5-13 Configuring QoS 162
- Figure 5-9 162
- Chapter 6 163
- Managing Security 163
- 6-2 Managing Security 164
- Figure 6-1 164
- Managing Security 6-3 165
- Figure 6-2 165
- 6-4 Managing Security 166
- Managing Security 6-5 167
- Figure 6-3 167
- 6-6 Managing Security 168
- Figure 6-4 168
- Managing Security 6-7 169
- Authentication List 170
- Port Authentication 171
- 6-10 Managing Security 172
- 6-12 Managing Security 174
- Managing Security 6-13 175
- Figure 6-8 175
- 6-14 Managing Security 176
- Traffic Control 177
- 6-16 Managing Security 178
- Figure 6-9 178
- Port Security 179
- 6-18 Managing Security 180
- Figure 6-10 180
- Protected Ports 181
- 6-20 Managing Security 182
- Figure 6-11 182
- MAC Rules 184
- Managing Security 6-23 185
- MAC Binding Configuration 186
- IPv4 ACL 187
- IPv4 Rules 188
- Managing Security 6-27 189
- IPv4 Binding Configuration 190
- IPv6 ACL 191
- IPv6 Rules 192
- Managing Security 6-31 193
- IPv6 Binding Configuration 194
- Binding Table 195
- Chapter 7 196
- Monitoring the Switch 196
- Logs Configuration 197
- Log Filter 198
- Memory Log 199
- 7-5 Monitoring the Switch 200
- Figure 7-3 200
- Flash Log 201
- Server Log 202
- Monitoring the Switch 7-8 203
- 7-9 Monitoring the Switch 204
- Monitoring the Switch 7-10 205
- Figure 7-6 205
- Monitoring the Switch 7-12 207
- Figure 7-7 207
- 7-13 Monitoring the Switch 208
- Monitoring the Switch 7-14 209
- 7-15 Monitoring the Switch 210
- Figure 7-8 210
- Monitoring the Switch 7-16 211
- Figure 7-9 211
- 7-17 Monitoring the Switch 212
- Monitoring the Switch 7-18 213
- Figure 7-10 213
- 7-19 Monitoring the Switch 214
- Figure 7-11 214
- Monitoring the Switch 7-20 215
- Figure 7-12 215
- 7-21 Monitoring the Switch 216
- Monitoring the Switch 7-22 217
- Port Mirroring 218
- Monitoring the Switch 7-24 219
- Chapter 8 220
- Maintenance 220
- Factory Default 221
- 8-3 Maintenance 222
- Figure 8-2 222
- Maintenance 8-4 223
- Figure 8-3 223
- Download 224
- File Management 225
- Troubleshooting 226
- Maintenance 8-8 227
- Figure 8-6 227
- Chapter 9 228
- Online Help 228
- User Guide 229
- Chapter A 230
- Default Settings 230
Related products and manuals for Networking Netgear GS748TS
Networking Netgear NMS100 User Manual
(69 pages)
(69 pages)
Networking Netgear DGN2000 User Manual
(126 pages)
(126 pages)
© 2020, manymanuals.com. All rights reserved. | 0.438 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals