Netgear GS748TS User Manual Page 131
- Page / 232
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
GS700TS Smart Switch Software Administration Manual
Configuring Switching Settings 4-38
v1.0, June 2009
– Designated – Indicates the port or LAG through which the designated switch is
attached to the LAN.
– Alternate – Provides an alternate path to the root switch from the root interface.
–Backup – Provides a backup path to the designated port path toward the Spanning
Tree leaves. Backup ports occur only when two ports are connected in a loop by a
point-to-point link, or when a LAN has two or more connections connected to a shared
segment.
– Disabled – Indicates the port is not participating in the Spanning Tree.
• Mode – Displays the current STP mode. The STP mode is selected in the STP
Configuration screen. The possible field values are:
– STP – Indicates Classic STP is enabled on the device.
– RSTP – Indicates Rapid STP is enabled on the device.
• Fast Link Operational Status – Displays the Fast Link status for the interface. If Fast
Link is enabled for a port, the port is automatically placed in the forwarding state. The
possible field values are:
– Enabled – Indicates Fast Link is enabled on the interface.
– Disabled – Indicates Fast Link is disabled on the interface.
• Status – Displays the RSTP status for the interface. The possible field values are:
– Enabled – Indicates RSTP is enabled on the interface.
– Disable – Indicates RSTP is disabled on the interface. This is the default value.
• Point-to-Point Admin Status – Select whether a point-to-point link is established. Ports
defined as Full Duplex are considered Point-to-Point port links. The possible field values
are:
– Enable – Enables a point-to-point link, or configure to automatically establish a point-
to-point link. To establish communications over a point-to-point link, the originating
PPP first sends Link Control Protocol (LCP) packets to configure and test the data
link. After a link is established and optional facilities are negotiated as needed by the
LCP, the originating PPP sends Network Control Protocol (NCP) packets to select and
configure one or more network layer protocols. When each of the chosen network
layer protocols has been configured, packets from each network layer protocol can be
sent over the link. The link remains configured for communications until explicit LCP
or NCP packets close the link, or until some external event occurs. This is the actual
switch port link type. It may differ from the administrative state.
- GS700TS Smart Switch 1
- Software Administration 1
- EU Statement of Compliance 3
- Customer Support 3
- Internet/World Wide Web 3
- Contents 5
- About This Manual 10
- About This Manual xi 11
- How to Use This Manual 12
- How to Print this Manual 13
- Revision History 13
- Chapter 1 14
- Switch Management Interface 15
- Network with a DHCP Server 16
- Figure 1-1 17
- Figure 1-2 17
- Network without a DHCP Server 18
- Stackable Smart Switch 19
- Web Access 20
- Additional Utilities 21
- Password Change 22
- Firmware Upgrade 22
- Figure 1-6 23
- Chapter 2 24
- The Navigation Menu 25
- Device Management Buttons 26
- Informational Services 27
- Figure 2-3 28
- Figure 2-4 28
- Figure 2-5 29
- Figure 2-6 29
- Figure 2-10 31
- Figure 2-11 32
- Figure 2-12 32
- Figure 2-13 33
- Figure 2-14 33
- Figure 2-15 34
- Figure 2-16 34
- Figure 2-17 35
- Chapter 3 36
- Managing System Settings 36
- Managing System Settings 3-2 37
- Figure 3-1 37
- V1.0, June 2009 38
- IP Configuration 39
- 3-5 Managing System Settings 40
- Managing System Settings 3-6 41
- Figure 3-3 41
- . The Secondary SNTP 42
- Device View 43
- Stacking 43
- Operation Modes 44
- Understanding Stack Topology 44
- Stacking Ports 45
- Stacking Members and Unit No 45
- 3-11 Managing System Settings 46
- Inserting a Stacking Member 47
- Exchanging Stacking Members 47
- Switching the Stacking Master 48
- Managing System Settings 3-14 49
- When the 49
- Figure 3-6 49
- 3-15 Managing System Settings 50
- Figure 3-7 50
- Managing System Settings 3-16 51
- Figure 3-8 51
- 3-17 Managing System Settings 52
- SNMPv1/v2 53
- 3-19 Managing System Settings 54
- Figure 3-9 54
- Managing System Settings 3-20 55
- 3-21 Managing System Settings 56
- Figure 3-10 56
- Managing System Settings 3-22 57
- 3-23 Managing System Settings 58
- Figure 3-11 58
- Managing System Settings 3-24 59
- Figure 3-12 59
- 3-25 Managing System Settings 60
- Figure 3-13 60
- Managing System Settings 3-26 61
- 3-27 Managing System Settings 62
- Figure 3-14 62
- Managing System Settings 3-28 63
- Figure 3-15 63
- 3-29 Managing System Settings 64
- Managing System Settings 3-30 65
- Figure 3-16 65
- 3-31 Managing System Settings 66
- Managing System Settings 3-32 67
- Figure 3-17 67
- 3-33 Managing System Settings 68
- Figure 3-18 68
- Managing System Settings 3-34 69
- 3-35 Managing System Settings 70
- Managing System Settings 3-36 71
- Figure 3-19 71
- 3-37 Managing System Settings 72
- Figure 3-20 72
- Managing System Settings 3-38 73
- 3-39 Managing System Settings 74
- Figure 3-21 74
- 3-41 Managing System Settings 76
- Figure 3-22 76
- Managing System Settings 3-42 77
- 3-43 Managing System Settings 78
- Figure 3-23 78
- Managing System Settings 3-44 79
- 3-45 Managing System Settings 80
- Figure 3-24 80
- Managing System Settings 3-46 81
- 3-47 Managing System Settings 82
- Figure 3-25 82
- Managing System Settings 3-48 83
- Figure 3-26 83
- 3-49 Managing System Settings 84
- Managing System Settings 3-50 85
- 3-51 Managing System Settings 86
- Figure 3-27 86
- Managing System Settings 3-52 87
- Figure 3-28 87
- 3-53 Managing System Settings 88
- Managing System Settings 3-54 89
- 3-55 Managing System Settings 90
- LLDP Statistics 91
- 3-57 Managing System Settings 92
- Figure 3-29 92
- Managing System Settings 3-58 93
- Chapter 4 94
- Figure 4-1 95
- Figure 4-2 98
- Figure 4-3 100
- Advanced 101
- Figure 4-5 102
- Figure 4-6 104
- Figure 4-7 105
- Figure 4-8 105
- Figure 4-9 106
- Figure 4-10 108
- Figure 4-12 111
- Figure 4-13 112
- Figure 4-14 113
- Voice VLAN 114
- Figure 4-16 115
- Properties 117
- Port Setting 118
- Figure 4-19 120
- Figure 4-20 122
- Figure 4-22 127
- Figure 4-23 128
- Figure 4-24 130
- Figure 4-25 133
- Figure 4-26 134
- Multicast 136
- The Multicast 141
- Figure 4-30 141
- The Multicast Forward 142
- Figure 4-31 143
- Address Table 144
- Figure 4-32 145
- Figure 4-34 147
- Figure 4-35 148
- Chapter 5 150
- Configuring QoS 150
- Configuring QoS 5-2 151
- 5-3 Configuring QoS 152
- Figure 5-1 152
- Configuring QoS 5-4 153
- Figure 5-2 153
- 5-5 Configuring QoS 154
- Figure 5-3 154
- Configuring QoS 5-6 155
- Figure 5-4 155
- Configuring QoS 5-8 157
- Figure 5-5 157
- 5-9 Configuring QoS 158
- Figure 5-6 158
- Configuring QoS 5-10 159
- Figure 5-7 159
- 5-11 Configuring QoS 160
- Configuring QoS 5-12 161
- Figure 5-8 161
- 5-13 Configuring QoS 162
- Figure 5-9 162
- Chapter 6 163
- Managing Security 163
- 6-2 Managing Security 164
- Figure 6-1 164
- Managing Security 6-3 165
- Figure 6-2 165
- 6-4 Managing Security 166
- Managing Security 6-5 167
- Figure 6-3 167
- 6-6 Managing Security 168
- Figure 6-4 168
- Managing Security 6-7 169
- Authentication List 170
- Port Authentication 171
- 6-10 Managing Security 172
- 6-12 Managing Security 174
- Managing Security 6-13 175
- Figure 6-8 175
- 6-14 Managing Security 176
- Traffic Control 177
- 6-16 Managing Security 178
- Figure 6-9 178
- Port Security 179
- 6-18 Managing Security 180
- Figure 6-10 180
- Protected Ports 181
- 6-20 Managing Security 182
- Figure 6-11 182
- MAC Rules 184
- Managing Security 6-23 185
- MAC Binding Configuration 186
- IPv4 ACL 187
- IPv4 Rules 188
- Managing Security 6-27 189
- IPv4 Binding Configuration 190
- IPv6 ACL 191
- IPv6 Rules 192
- Managing Security 6-31 193
- IPv6 Binding Configuration 194
- Binding Table 195
- Chapter 7 196
- Monitoring the Switch 196
- Logs Configuration 197
- Log Filter 198
- Memory Log 199
- 7-5 Monitoring the Switch 200
- Figure 7-3 200
- Flash Log 201
- Server Log 202
- Monitoring the Switch 7-8 203
- 7-9 Monitoring the Switch 204
- Monitoring the Switch 7-10 205
- Figure 7-6 205
- Monitoring the Switch 7-12 207
- Figure 7-7 207
- 7-13 Monitoring the Switch 208
- Monitoring the Switch 7-14 209
- 7-15 Monitoring the Switch 210
- Figure 7-8 210
- Monitoring the Switch 7-16 211
- Figure 7-9 211
- 7-17 Monitoring the Switch 212
- Monitoring the Switch 7-18 213
- Figure 7-10 213
- 7-19 Monitoring the Switch 214
- Figure 7-11 214
- Monitoring the Switch 7-20 215
- Figure 7-12 215
- 7-21 Monitoring the Switch 216
- Monitoring the Switch 7-22 217
- Port Mirroring 218
- Monitoring the Switch 7-24 219
- Chapter 8 220
- Maintenance 220
- Factory Default 221
- 8-3 Maintenance 222
- Figure 8-2 222
- Maintenance 8-4 223
- Figure 8-3 223
- Download 224
- File Management 225
- Troubleshooting 226
- Maintenance 8-8 227
- Figure 8-6 227
- Chapter 9 228
- Online Help 228
- User Guide 229
- Chapter A 230
- Default Settings 230
Related products and manuals for Networking Netgear GS748TS
Networking Netgear NMS100 User Manual
(69 pages)
(69 pages)
Networking Netgear DGN2000 User Manual
(126 pages)
(126 pages)
© 2020, manymanuals.com. All rights reserved. | 1.166 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals