Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 64)

700 Series Managed Switch User’s Guide for Software v2.1

5-14 Web-Based Management Interface

SM-10004-02

Click Apply to change the IP settings

Save Configuration to NVRAM and reset the system to implement the changes (Tools > Save

Configuration).

Set-up> Port Configuration

Figure 5-14: Port Configuration

This menu allows you can configure the status of each port.

• Port: The port number on the switch

• Name: The name of the port. This is a user-defined label.

• Link: A green triangle pointing up indicates a valid link, while a red triangle

pointing down indicates no link.

• On/Off: Indicates if the port is enabled or disabled by the Administrator.

• State: This refers to the Spanning Tree state of the port. Ports will be Blocking

(Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled

(Dis).

• Speed: Indicates the speed and duplex for the port. The possible entries are

Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full

duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full

duplex (100M Full).

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 64