Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 61)

700 Series Managed Switch User’s Guide for Software v2.1

Web-Based Management Interface 5-11

SM-10004-02

• Link: A green triangle pointing up indicates a valid link, while a red triangle

pointing down indicates no link.

• On/Off: Indicates if the port is enabled or disabled by the Administrator.

• State: This refers to the Spanning Tree state of the port. Ports will be Blocking

(Blk), Listening (Lis), Learning (Lrn), Forwarding (Fwd) or Disabled (Dis).

• Speed: Indicates the speed and duplex for the port. The possible entries are

Auto-negotiation (Auto); 10 Mbps half duplex (10M Half); 10 Mbps full

duplex (10M Full); 100 Mbps half duplex (100M Half); or 100 Mbps full

duplex (100M Full).

• Flow Control: Indicates whether Flow Control support is set for automatic (Auto) or off

(Disabled)

• Priority Indicates if the port is set to high priority or normalpriority. This is an

advanced feature that is configured under Traffic Prioritization

• Trunk ID Indicates if the port is a member of a trunk by showing the ID number of the

trunk. This is an advanced feature that is configured under Port Trunking

Status > MAC Address Table

Figure 5-10: MAC Address Table

The MAC Address Table is a dynamic address lookup table that allows you to view the dynamic

MAC addresses that are currently in the address database. When a MAC address is in the database,

the packets intended for that address are forwarded directly to that port. You can filter the

displayed addresses by port, VLAN, and/or MAC address by checking those fields.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 61