Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 104)

700 Series Managed Switch User’s Guide for Software v2.1

6-14 Command Line Interface

SM-10004-02

When the interface command is properly entered, you will be taken to the Interface Configuration

Mode, where the prompt changes from

FSM726(config)# to FSM726(config-if)#.

When you are done configuring one particular interface and wish to configure another interface,

you must exit the Interface Configuration Mode by using the

exit command. You then have to

re-enter Interface Configuration Mode by specifying another interface, again, using the

interface command

When you’re in interface configuration mode, you will be able to configure the following items.

CoS (Class or Service)

Class of Service (CoS) is a way of managing traffic in a network by treating different types of

traffic with different levels of service priority. Higher priority traffic gets faster treatment during

times of switch congestion.

Syntax

FSM726(config-if)# cos <normal/high>

Where

<normal/high> = the priority given to the port. When set to high, traffic from and destined for

this port will take priority over traffic from other ports.

Description

This command allows you to assign a name or description to a port.

syntax

FSM726(config-if)# description <description>

where

<description> = the description you wish to give to this particular interface

Duplex

Syntax

FSM726(config-if)# duplex <duplex operation>

Where

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 104