Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 103)

700 Series Managed Switch User’s Guide for Software v2.1

Command Line Interface 6-13

SM-10004-02

FSM726(config)# diffserv <DSCP> <priority>

Where

<DSCP> = The DSCP value, which ranges from 0-63

<Priority> = The priority associated with the defined DSCP value. The available options are

normal and high

For example, suppose you want to set DSCP 33 to high, the command to do so would be:

FSM726(config)# diffserv 33 high

Exit

The exit command takes you out of the CLI mode by one level. For example, when you are in

configuration mode, and the prompt looks like

FSM726(config)#. By entering exit at the

prompt, you will exit the configuration mode and be taken back to the root level, where the prompt

looks like

FSM726#. When you enter the exit command at the root level, you will return to the

Main Menu of the switch.

Syntax

FSM726(config)# exit

Interface

The interface command allows you to configure each network interface of the switch. Items

such as the speed, duplex, and negotiation are configured in this mode. The command to enter the

interface mode is

Syntax

FSM726(config)# interface ethernet <x/y>

Where

<x/y> = x is the stack number, and y is the port number, which ranges from 1-26. Since FSM726

is not stackable, the value of x is always 1.

For example, suppose you want to configure port 8 on the switch, the command to do so would be:

FSM726(config)# interface ethernet 1/8

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 103