Netgear 700 Series Managed Switch for Software v2.1 User Manual download pdf (Page 102)

700 Series Managed Switch User’s Guide for Software v2.1

6-12 Command Line Interface

SM-10004-02

<VLAN index #> = The VLAN ID. Adding the VLAN ID to the show vlan command displays

the port that belongs to that particular VLAN. For example, show vlan 1 displays the ports that

belong to VLAN 1.

An example of the display output is shown below:.

Untagged port members: 4,5,7,11-15,19-23

Tagged port members: none

COS-PVID

The show vlan cos-pvid displays the PVIDs and the CoS settings of each port.

Syntax

FSM726# show vlan cos-pvid

An example of the display output is shown below:

Port PVID Priority

------------------------

1:1 1 Normal

1:2 1 Normal

1:3 1 Normal

1:4 1 Normal

1:5 1 Normal

Configure

Entering the command configure at the root prompt takes you into configuration mode. When

you’re in configuration mode, the prompt changes to

FSM726(config)#

It is in this mode where the vast majority of configuration is performed. To exit the configuration

mode and return to root prompt, use the exit command.

DiffServ

DiffServ divides traffic into one of 64 classes using the packet’s DSCP value. This allows for

greater differentiation of traffic priority than port-based traffic prioritization.

Syntax

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 151 152

No comments

Netgear 700 Series Managed Switch for Software v2.1 User Manual Page 102