Netgear WG102 User Manual download pdf (Page 28)

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point

3-3 Basic Installation and Configuration

October 2004

Default Factory Settings

When you first receive your WG102, the default factory settings will be set as shown below. You

can restore these defaults with the Factory Default Restore switch on the rear panel — see

“WG102 front panel” on page 2-6.

FEATURE FACTORY DEFAULT SETTINGS

User Name (case sensitive) admin

Password (case sensitive) password

Operating Mode Access Point

Access Point Name netgearxxxxxx where xxxxxx are the last six digits

of the wireless access point's MAC address

Built-in DHCP client DHCP client disabled, it uses the default IP address

IP Configuration IP Address: 192.168.0.229

Subnet Mask: 255.255.255.0

Gateway: 0.0.0.0

Network Name (SSID)

NETGEAR

Broadcast Network Name (SSID Enabled

802.11g Radio Frequency Channel 11

WEP/WPA Disabled

Restricting connectivity based on MAC

Access Control List

Disabled

Time Zone GMT

Time Zone Adjust for Daylight Saving TIme Disabled

SNMP Disabled

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 101 102

No comments

Netgear WG102 User Manual Page 28