Netgear WG102 User Manual download pdf (Page 35)

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point

Basic Installation and Configuration 3-10

October 2004

Note: By default, WG102 is set to with the DHCP client disabled. If your network uses

dynamic IP addresses, you will need to change this setting.

d. Connect the power adapter to the wireless access point and plug the power adapter in to a

power outlet. The PWR, LAN, and WLAN lights should light up.

4VERIFY WIRELESS CONNECTIVITY

Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless

settings needed to connect to the WG102 (SSID, WEP/WPA, MAC ACL, etc.), verify

connectivity by using a browser such as Netscape or Internet Explorer to browse the Internet,

or check for file and printer access on your network.

Note: If you are unable to connect, see Chapter 6, “Troubleshooting.”

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 101 102

No comments

Netgear WG102 User Manual Page 35