Netgear WG102 User Manual download pdf (Page 69)

Troubleshooting 6-1

October 2004

Chapter 6

Troubleshooting

This chapter provides information about troubleshooting your NETGEAR WG102 ProSafe

802.11g Wireless Access Point. After each problem description, instructions are given to help you

diagnose and solve the problem. For the common problems listed, go to the section indicated.

• Is the WG102 on?

• Have I connected the wireless access point correctly?

Go to “Installing the WG102 Access Point” on page 3-5.

• I cannot remember the wireless access point’s configuration password.

Go to “Changing the Administrator Password” on page 4-8.

If you have trouble setting up your WG102, check the tips below.

No lights are lit on the access point.

It takes a few seconds for the power indicator to light up. Wait a minute and check the

power light status on the access point.

If the access point has no power.

• Make sure the power cord is connected to the access point.

• Make sure the power adapter is connected to a functioning power outlet. If it is in a power

strip, make sure the power strip is turned on. If it is plugged directly into the wall, verify that it

is not a switched outlet.

• Make sure you are using the correct NETGEAR power adapter supplied with your access

point.

Note: For up-to-date WG102 installation details and troubleshooting guidance visit

www.NETGEAR.com.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 101 102

No comments

Netgear WG102 User Manual Page 69