Netgear WG102 User Manual download pdf (Page 43)

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point

Basic Installation and Configuration 3-18

October 2004

How to Set Up and Test Basic Wireless Connectivity

Follow the instructions below to set up and test basic wireless connectivity. Once you have

established basic wireless connectivity, you can enable security settings appropriate to your needs.

1. Log in to the WG102 using its default address of http://192.168.0.229 or at whatever IP

address the unit is currently configured. Use the default user name of admin and default

password of password, or whatever password you set up.

2. Click the Wireless Settings link in the main menu of the WG102.

3. Choose a suitable descriptive name for the wireless network name (SSID). In the SSID box,

enter a value of up to 32 alphanumeric characters. The default SSID is NETGEAR.

Note: The SSID of any wireless access adapters must match the SSID you configure in the

NETGEAR WG102 ProSafe 802.11g Wireless Access Point. If they do not match, you will

not get a wireless connection to the WG102.

4. Select the Country/Region in which the wireless interface will operate.

5. Set the Channel. It should not be necessary to change the wireless channel unless you notice

interference problems or are near another wireless access point. Select a channel that is not

being used by any other wireless networks within several hundred feet of your wireless access

point. For more information on the wireless channel frequencies see “Wireless Channels” on

page B-7.

6. For initial configuration and testing, leave the Wireless Card Access List set to “Everyone”

and the Encryption Strength set to “Disabled.”

7. Click Apply to save your changes.

8. Configure and test your PCs for wireless connectivity.

Program the wireless adapter of your PCs to have the same SSID and channel that you

configured in the WG102. Check that they have a wireless link and are able to obtain an IP

address by DHCP from the WG102.

Once your PCs have basic wireless connectivity to the WG102, you can configure the advanced

wireless security functions.

Note: If you are configuring the WG102 from a wireless computer and you change the

SSID, channel, or security settings, you will lose your wireless connection when you

click Apply. You must then change the wireless settings of your computer to match the

new settings.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 101 102

No comments

Netgear WG102 User Manual Page 43