Netgear PROSAFE WG302v2 User Manual Page 97

  • Download
  • Add to my manuals
  • Print
  • Page
    / 102
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 96
NETGEAR ProSafe 802.11g Wireless Access Point WG302v2 Reference Manual
Command Line Reference C-15
v1.0, May 2006
Viewing and Configuring System Information
The commands in Table C-12 correspond to the pages on the Web UI under the Information
heading. This section includes commands for the following features:
Activity Log
Available Wireless Station List
Statistics
Rogue AP Detection
Table C-13 AP Information
Task Command
View the SysLog activity log get log-entry
View all SysLog server information
get log detail
Enable SysLog set log relay-enabled 1
Disable SysLog set log relay-enabled 0
Set the IP address of the SysLog server set log relay-host <ip_address>
Set the port number configured in the
SysLog server
set log relay-port <port_number>
View a list of wireless stations
get association detail
View interface statistics get interface all ip mac ssid
tx-packets tx-bytes tx-errors
rx-packets rx-bytes rx-errors
Turn Rogue AP Detection On
set radio wlan0 ap-detection on
Turn Rogue AP Detection Off
set radio wlan0 ap-detection off
View a list of unknown APs
get unknown-ap
View a list of known APs
get known-ap-config
Add an AP to the Known AP list
add known-ap-config <mac_address>
Delete an AP from the Known AP list
remove known-ap-config <mac_address>
Delete all APs from the Known AP list
remove known-ap-config all
Page view 96
1 2 ... 92 93 94 95 96 97 98 99 100 101 102

Comments to this Manuals

No comments