Netgear MBR1516 User's Guide download pdf (Page 72)

Advanced Settings

Mobile LTE Broadband 11n Wireless Router MBR1516

Wireless repeater. The router sends all traffic from its local wireless or wired computers to a

remote access point. To configure this mode, you have to know the MAC address of the

remote parent access point.

The MBR1516 router is always in dual band concurrent mode, unless you turn off one radio.

Be aware that if you enable the wireless repeater in either radio band, the wireless base

station or wireless repeater cannot be enabled in the other radio band. However, if you

enable the wireless base station in either radio band and use the other radio band as a

wireless router or wireless base station, dual band concurrent mode is not affected.

For you to set up a wireless network with WDS, the following conditions have to be met for

both access points:

• Both access points have to use the same SSID, wireless channel, and encryption mode.

• Both access points have to be on the same LAN IP subnet. That is, all the access point

LAN IP addresses are in the same network.

• All LAN devices (wired and wireless computers) have to be configured to operate in the

same LAN network address range as the access points.

Wireless Repeating Function

Select ADVANCED > Advanced > Wireless Repeating to view or change wireless repeater

settings for the router.

• Enable Wireless Repeating Function. Select the check box for the 2.4 GHz or 5 GHz

network to use the wireless repeating function.

• Wireless MAC of this router. This field displays the MAC address for your router for your

reference. You need to enter this MAC address in the corresponding Wireless Repeating

Function screen of the other access point you are using.

• Wireless Repeater. If your router is the repeater, select this radio button.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 215 216

No comments

Netgear MBR1516 User's Guide Page 72