Netgear D6200 User Manual Page 138

  • Download
  • Add to my manuals
  • Print
  • Page
    / 162
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 137
Advanced Settings
138
D6200 WiFi DSL Modem Router
No address data input is required.
Otherwise, select the desired option (IP address or domain name) and enter the
address of the remote VPN endpoint you wish to connect to.
The remote VPN endpoint must have this VPN gateway’s address entered as its
remote VPN endpoint.
- IKE Keep Alive. Check this check box if you wish to ensure that a connection is
kept open, or, if that is not possible, it is quickly reestablished when disconnected.
The ping IP address has to be associated with the remote endpoint. Either the
WAN or a LAN address can be used; a LAN address is preferable. This IP
address is pinged to generate some traffic for the VPN tunnel.
Local LAN. These settings identify which computers on your LAN are covered by this
policy. For each selection, data must be provided as follows:
- Single address. Enter an IP address in the Single/Start IP address field.
Typically, this setting is used when you wish to make a single server on your LAN
available to remote users.
- Range address. Enter the starting IP address in the Single/Start IP address field,
and the finish IP address in the Finish IP address field.
A range must be an address range used on your LAN.
- Subnet address. Enter an IP address in the Single/Start IP address field, and the
desired network mask in the Subnet Mask field.
The remote VPN endpoint must have these IP addresses entered as its remote
addresses.
Remote LAN. These settings identify which computers on the remote LAN are
covered by this policy. For each selection, data must be provided as follows:
- Single PC - no Subnet. Select this option if there is no LAN (only a single
computer) at the remote endpoint.
If this option is selected, no additional data is required.
- Single address. Enter an IP address in the Single/Start IP address field.
This value must be an address on the remote LAN. Typically, this setting is used
when you wish to access a server on the remote LAN.
- Range address. Enter the starting IP address in the Single/Start IP address field,
and the finish IP address in the Finish IP address field.
This range must be an address range used on the remote LAN.
- Subnet address. Enter an IP address in the Single/Start IP address field, and the
desired network mask in the Subnet Mask field.
The remote VPN endpoint must have these IP addresses entered as its local
addresses.
Page view 137
1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 161 162

Comments to this Manuals

No comments