Netgear XM128 ISDN User Manual download pdf (Page 113)

Reference Guide for the Model XM128 ISDN Digital Modem

AT Command Set Reference C-11

&Wn n=0-3 Writes current settings to user profile n in nonvolatile RAM. See also

S-register 35.6. For a description of Extended S-registers, refer to Table D-4

on page D-5 in Appendix D, “Status Registers and Result Codes."

&Z? Display all the phone numbers stored in nonvolatile RAM.

&Zn=s n=0-39 Write phone number/s to NVRAM at location n (n=0-39); use AT*Dn or

ATS29=n to set the default dial pointer.

&ZIn=s

s=phone number

n=0-7

MSN setting. Assign the phone number (including subaddress, if any) for

various B channel protocols. In answer mode, these numbers are compared

with the received called_party_number and called_party_subaddress

information. The call is accepted using the specific protocol if the assigned

number of this protocol matches with the called_party_number.

n=0 Assigns multiple subscriber number (MSNs) phone number for X.75.

n=1 Assigns MSNs phone number for V.110.

n=2 Assigns MSNs phone number for V.120.

n=3 Assigns MSNs phone number for PPP, MPPP.

n=4 Assigns MSNs for ISDN data, protocol auto-detection.

n=6 Assigns the phone number s for analog adapter,

PHONE 1.

n=7 Assigns the phone number s for the analog adapter, PHONE 2.

&ZI? Displays the phone number (including subaddress, if any) for various B

channel protocols.

&ZO? Displays the &ZOn setting.

&ZOn=x Writes own phone number (including subaddress, if any). The number

specified is used as the calling party number while dialing. Value for n:

I = ISDN data

A = analog adapter, PHONE 1

B = analog adapter, PHONE 2

Table C-3. Extended AT& command set (continued)

Command Options Function and description

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 155 156

No comments

Netgear XM128 ISDN User Manual Page 113