Netgear XM128 ISDN User Manual download pdf (Page 109)

Reference Guide for the Model XM128 ISDN Digital Modem

AT Command Set Reference C-7

Description of ATI3 Output

The Link Status Report output is displayed on the screen as follows:

NETGEAR ISDN Modem LINK STATUS REPORT

Connect DTE Speed :

Error Control Level :

Protocol Link Speed :

Octets Received : 0

Octets Sent : 0

Cause :

Cause Value : 0

HDLC FCS Error : 0

HDLC Receive Over-run : 0

HDLC Transmit Under-run : 0

SPIDn=m User enters Service Profile ID (SPID) m, for USA switches.

SPID0 First SPID number

SPID1 Second SPID number, if any.

SPID? Display the SPID setting(s).

UPX Download firmware to the flash EPROM using X-modem Protocol.

Vn Sets display type for result codes. See also S-register 23.6. For a description

of Extended S-registers, refer to Table D-4 on page D-5 in Appendix D, “Status

Registers and Result Codes."

V0 Displays result code in numeric form. See also S-register 35.7 and the result

code table of ATXn. For a description of Extended S-registers, refer to

Table D-4 on page D-5 in Appendix D, “Status Registers and Result Codes."

V1 * Displays result code in verbose form.

Xn n=0-7

5 *

Result code options. See the options table. See also S-registers 23.3 to 23.5.

For a description of Extended S-registers, refer to Table D-4 on page D-5 in

Appendix D, “Status Registers and Result Codes."

Zn n=0-4 Resets the Model XM128 modem and sets power-on profile. See also

S-registers15.5 to 15.7. For a description of Extended S-registers, refer to

Table D-4 on page D-5 in Appendix D, “Status Registers and Result Codes."

Zn Resets the Model XM128 modem and loads user profile n (0-3).

Z4 Resets the Model XM128 modem and loads factory settings.

$ Basic command summary help

Table C-1. Basic AT command set (continued)

Command Options Function and description

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 155 156

No comments

Netgear XM128 ISDN User Manual Page 109