Netgear WNR2000-200UKS User Manual download pdf (Page 68)

Specify Network Settings

N300 WiFi Router

5. Select ADVANCED > Advanced Setup > Wireless AP.

6. Select the Enable AP Mode check box.

7. Scroll down and select a radio button for the IP address setting:

• Get dynamically from existing router. The other router on the network assigns an

IP address to this router while this router is in AP mode.

• Enable fixed IP settings on this device (not recommended). Use this setting if you

want to manually assign a specific IP address to this router while it is in

AP mode.

Using this option effectively requires advanced network experience.

Note: To avoid interference with other routers or gateways in your network,

NETGEAR recommends that you use different wireless settings on

each router. You can also turn off the wireless radio on the other router

or gateway and use the WNR2000v5 only for wireless client access.

8. Click the Apply button.

The IP address of the router changes and you are disconnected.

To reconnect, close and restart your browser and type http://wwwrouterlogin.net.

Set Up a WiFi Guest Network

A guest network allows visitors at your home to use the Internet without using your wireless

security key. You can add a guest network to each wireless network: 2.4 GHz b/g/n and

5.0 GHz a/n.

 To set up a guest network:

1. Launch a web browser from a computer or wireless device that is connected to the

network.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 112 113

No comments

Netgear WNR2000-200UKS User Manual Page 68