Page 9 of 9 CHAPTER 2: PHYSICAL DESCRIPTION This chapter describes the hardware features of the NETGEAR Model FSM726 Managed Switch. Topics include: F
Page 10 of 10 • After ascertaining this information, the switch automatically configures the RJ-45 port to enable communications with the attached de
Page 11 of 11 LED Descriptions The front panel of the NETGEAR Model FSM726 Managed Switch has LEDs that provide a quick and accurate display of port s
Page 12 of 12 In addition to using the console port, you can manage the switch using a Web browser or a Simple Network Management Protocol (SNMP) mana
Page 13 of 13 CHAPTER 3: INSTALLATION This chapter describes the installation procedures for your NETGEAR Model FSM726 Managed Switch. Switch installa
Page 14 of 14 Step 2: Installing the Switch You can install your NETGEAR Model FSM726 Managed Switch on a flat surface or in a standard 19-inch rack.
Page 15 of 15 cord, select an AC outlet that is not controlled by a wall switch, which can turn off power to the switch. After you select an appropria
Page 16 of 16 2. After the switch has been configured for management (Step 7), use one of the management interfaces (web browser or console interface
Page 17 of 17 Parity: none Stop bit: 1 Flow control: none 4. Hit the return key, and the below screen should appear. Figure 3-4. System Information 5
Page 18 of 18 2. Select ‘C’ for Set-up 3. Select ‘B’ for IP configuration 4. Enter in the IP address, Subnet mask, and Default Gateway 5. Hit ‘Q’
Page 1 of 1 © 2005 by NETGEAR, Inc. NETGEAR, the Netgear logo, Auto Uplink, ProSafe and Everybody's connecting are trademarks or registered trade
Page 19 of 19 APPENDIX A: TECHNICAL SPECIFICATIONS This appendix provides technical specifications for the NETGEAR Model FSM726 Managed Switch. Netwo
Page 20 of 20 Power Supply DC power consumption: 15 W maximum 100-240VAC/50-60 Hz u
Page 21 of 21 APPENDIX B: TROUBLESHOOTING This chapter provides information about troubleshooting the NETGEAR Model FSM726 Managed Switch. Topics incl
Page 22 of 22 Configuration If problems occur after altering the network configuration, restore the original connections and determine the problem by
Page 23 of 23 APPENDIX C: Default Settings This appendix provides the default settings for the NETGEAR Model FSM726 Managed Switch. Feature FSM726 D
Page 2 of 2 Canadian Department of Communications Radio Interference Regulations This digital apparatus (NETGEAR Model FSM726 Managed Switch) do not e
Page 3 of 3 CONTENTS CHAPTER 1: INTRODUCTION...
Page 4 of 4 Figures FIGURE 1-1. PACKAGE CONTENTS ...
Page 5 of 5 CHAPTER 1: INTRODUCTION Congratulations on your purchase of a NETGEAR Model FSM726 Managed, Fast Ethernet Switch! Your NETGEAR Switch is a
Page 6 of 6 Features • The following list identifies the key features of the NETGEAR Model FSM726 Managed Switch. • Twenty-four 10/100 Mbps auto sen
Page 7 of 7 • Automatic address learning function to build the packet-forwarding information table. The table contains up to 8,000 media access contr
Page 8 of 8 Package Contents Figure 1-1 shows the package contents for the Managed Switch. Figure 1-1. Package Contents Verify that your package
Comments to this Manuals