Netgear RP614 User Manual download pdf (Page 79)

Troubleshooting 8-1

Chapter 8

Troubleshooting

This chapter gives information about troubleshooting your Model RP614 Web Safe Router. After

each problem description, instructions are provided to help you diagnose and solve the problem.

Basic Functioning

After you turn on power to the router, the following sequence of events should occur:

1. When power is first applied, verify that the Power LED is on.

2. Verify that the Test LED lights within a few seconds, indicating that the self-test

procedure is running.

3. After approximately 10 seconds, verify that:

a. The Test LED is not lit.

b. The LAN port LEDs are lit for any local ports that are connected.

c. The WAN port LED is lit.

If a port’s LED is lit, a link has been established to the connected device. If a LAN port is

connected to a 100 Mbps device, verify that the port’s LED is green. If the port is 10 Mbps, the

LED will be amber.

If any of these conditions does not occur, refer to the appropriate following section.

Power LED Not On

If the Power and other LEDs are off when your router is turned on:

• Make sure that the power cord is properly connected to your router and that the power supply

adapter is properly connected to a functioning power outlet.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 106 107

No comments

Netgear RP614 User Manual Page 79