Netgear RP614 User Manual download pdf (Page 75)

Reference Manual for the Model RP614 Web Safe Router

Advanced Configuration of the Router 7-9

— When set to Both or In Only, it will incorporate the RIP information that it receives.

— When set to None, it will not send any RIP packets and will ignore any RIP packets

received.

• RIP Version

This controls the format and the broadcasting method of the RIP packets that the router sends.

(It recognizes both formats when receiving.) By default, this is set for RIP-1.

— RIP-1 is universally supported. RIP-1 is probably adequate for most networks, unless you

have an unusual network setup.

— RIP-2 carries more information. RIP-2B uses subnet broadcasting..

Static Routes

Static Routes provide additional routing information to your router. Under normal circumstances,

the router has adequate routing information after it has been configured for Internet access, and

you do not need to configure additional static routes. You must configure static routes only for

unusual cases such as multiple routers or multiple IP subnets located on your network.

Note: If you change the LAN IP address of the router while connected through the

browser, you will be disconnected. You must then open a new connection to the new IP

address and log in again.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 106 107

No comments

Netgear RP614 User Manual Page 75