Netgear R6100 User Manual download pdf (Page 67)

Security

R6100 WiFi Router

If the Disable Port Triggering check box is selected after you configure port triggering,

port triggering is disabled. However, any port triggering configuration information that you

specified is saved even though it is not used.

4. In the Port

Triggering Timeout field, enter a value up to 9999 minutes.

This value controls the inactivity timer for the designated inbound ports. The inbound

ports close when the inactivity time expires.

This is required because the router cannot be

sure when the application has terminated.

 To add a port triggering service:

1. On the Port Forwarding/Port

Triggering screen, click the Add Service button.

2. In the Service Name field, type a descriptive service name.

3. In the Service User list, select Any, or select Single address and enter the IP address of

one computer

• Any (the default), allows any computer on the Internet to use this service.

• Single address restricts the service to a particular computer

4. Select the service type, either TCP or UDP or TCP/UDP (both). If you are not sure, select

TCP/UDP

5. In the

Triggering Port field, enter the number of the outbound traffic port that will cause the

inbound ports to be opened.

6. Enter the inbound connection port information in the Connection

Type, Starting Port, and

Ending Port fields.

7. Click the Apply button.

The service appears in the Port Triggering Portmap Table.

8. Make sure that you enable port triggering so that the service that you added will be used.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 121 122

No comments

Netgear R6100 User Manual Page 67