Netgear Double 108 Mbps Wireless PC Card WG511U User Manual download pdf (Page 70)

User’s Manual for the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus WG511U

B-18 Wireless Networking Basics

August 2004

The AP sends Beacon Frames with WPA information element to the stations in the service set.

Information elements include the required authentication method (802.1x or Pre-shared key) and

the preferred cipher suite (WEP, TKIP, or AES). Probe Responses (AP to station) and Association

Requests (station to AP) also contain WPA information elements.

1. Initial 802.1x communications begin with an unauthenticated supplicant (i.e., client device)

attempting to connect with an authenticator (i.e., 802.11 access point). The client sends an

EAP-start message. This begins a series of message exchanges to authenticate the client.

2. The access point replies with an EAP-request identity message.

3. The client sends an EAP-response packet containing the identity to the authentication server.

The access point responds by enabling a port for passing only EAP packets from the client to

an authentication server located on the wired side of the access point. The access point blocks

all other traffic, such as HTTP, DHCP, and POP3 packets, until the access point can verify the

client's identity using an authentication server (e.g., RADIUS).

4. The authentication server uses a specific authentication algorithm to verify the client's identity.

This could be through the use of digital certificates or some other EAP authentication type.

5. The authentication server will either send an accept or reject message to the access point.

6. The access point sends an EAP-success packet (or reject packet) to the client.

7. If the authentication server accepts the client, then the access point will transition the client's

port to an authorized state and forward additional traffic.

The important part to know at this point is that the software supporting the specific EAP type

resides on the authentication server and within the operating system or application “supplicant”

software on the client devices. The access point acts as a “pass through” for 802.1x messages,

which means that you can specify any EAP type without needing to upgrade an 802.1x-compliant

access point. As a result, you can update the EAP authentication type to such devices as token

cards (Smart Cards), Kerberos, one-time passwords, certificates, and public key authentication or

as newer types become available and your requirements for security change.

IEEE 802.1x offers an effective framework for authenticating and controlling user traffic to a

protected network, as well as providing a vehicle for dynamically varying data encryption keys via

EAP from a RADIUS server, for example. This framework enables using a central authentication

server, which employs mutual authentication so that a rogue wireless user does not join the

network.

It's important to note that 802.1x doesn't provide the actual authentication mechanisms. When

using 802.1x, the EAP type, such as Transport Layer Security (EAP-TLS) or EAP Tunneled

Transport Layer Security (EAP-TTLS) defines how the authentication takes place.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 94 95

No comments

Netgear Double 108 Mbps Wireless PC Card WG511U User Manual Page 70