Netgear Double 108 Mbps Wireless PC Card WG511U User Manual download pdf (Page 19)

Basic Setup 3-1

August 2004

Chapter 3

Basic Setup

This chapter describes how to install your NETGEAR Double 108 Mbps Wireless PC Card 32-bit

CardBus WG511U and set up basic wireless connectivity on your Wireless Local Area Network

(WLAN). Advanced wireless network configuration is covered in Chapter 4, “Netgear Smart

Wireless Wizard” in this manual.

What You Need Before You Begin

You need to verify your computer meets the minimum system requirements and identify the

wireless network configuration settings of the WLAN where you will connect before you can

configure your wireless PC card and connect.

Verifying System Requirements

Before installing the NETGEAR Double 108 Mbps Wireless PC Card 32-bit CardBus WG511U,

please make sure that these minimum requirements have been met:

• You must have a notebook PC with a Pentium

300 MHz or higher compatible processor with

an available CardBus slot.

Note: The WG511U requires a CardBus slot. If you are not sure about what type of slot your

computer has, consult the documentation or manufacturer’s web site for your computer.

•A CD-ROM drive.

• 5 Mbytes of free hard disk space.

Note: Indoors, computers can easily connect to 802.11 wireless networks at distances of

several hundred feet. Because walls do not always block wireless signals, others outside

your immediate area could access your network. It is important to take appropriate steps

to secure your network from unauthorized access. The NETGEAR Double 108 Mbps

Wireless PC Card 32-bit CardBus WG511U provides highly effective security features

which are covered in “Wireless Security Configuration” on page 5-1 in this manual.

Deploy the security features appropriate to your needs.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 94 95

No comments

Netgear Double 108 Mbps Wireless PC Card WG511U User Manual Page 19