Netgear ADSL Firewall Router DG834 User Manual Page 119

  • Download
  • Add to my manuals
  • Print
  • Page
    / 236
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 118
Reference Manual for the ADSL Firewall Router DG834
Virtual Private Networking (Advanced Feature) 7-29
202-10005-05, June 2005
To activate the VPN tunnel by pinging the remote endpoint (e.g., 192.168.3.1), do the following
steps depending on whether your configuration is client-to-gateway or gateway-to-gateway:
Client-to-Gateway Configuration—to check the VPN Connection, you can initiate a request
from the remote PC to the DG834’s network by using the “Connect” option in the NETGEAR
ProSafe menu bar. The NETGEAR ProSafe client will report the results of the attempt to
connect. Since the remote PC has a dynamically assigned WAN IP address, it must initiate the
request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type ping -t 192.168.3.1 and then click OK.
Figure 7-32: Running a Ping test to the LAN from the PC
This will cause a continuous ping to be sent to the first DG834. After between several
seconds and two minutes, the ping response should change from “timed out” to “reply.”
Note: Use Cntl-C to stop the pinging.
Figure 7-33: Ping test results
Page view 118
1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 235 236

Comments to this Manuals

No comments